The necessary steps involved to tear apart a Samsung dryer are relatively simple. Before taking the dryer apart you want to unplug or disconnect power to the dryer first.
Pull the dryer forward because the top is held down with two screws coming in from the back. Remove the screws and the top will slide back and off.
With the top off, the control panel will be accessible. The control is clipped into plastic clips, there are no screws to remove the control panel. With the panel Un-clipped, you will see the wire harness that needs to be disconnected. Depress the wire harness tab and the control will pull free.
Remove the two screws that are located on the lint filter housing near the bottom of the door opening. The screws that were hidden by the base of the control panel will need to be removed along the top of the front panel.
When the screws are off, depress the two clips that hold the front to the cabinet and pull the front panel forward to reveal the door switch. Now that you have access to the door switch, Un-clip the door switch and the front panel will lift up and off the unit. Samsung does not place screws on the lower front panel; the panel sits in a metal groove dryer repair van nuys.
Samsung uses a bulkhead on the front of their units, remove the four screws that are holding the bulkhead to the cabinet.
There are 2 screws along the left side and 2 on the right side. Once the screws are removed, the bulkhead will lift out of the holding slot enabling access to the dryer belt. Notice the routing of the belt before removal, using a camera or drawing will help you assembly if dryer belt routing is forgotten.
With the belt removed, the drum will lift up and out of the dryer and give you access to the all of the components. Now you can use your volt and ohm meter to diagnose the unit properly for whatever electrical/heating issues you may be having.
Samsung dryers are a bit different from American built dryers. Samsung uses different technology in both their washer and dryers that a Whirlpool or Maytag washer or dryer does not have. This is good and bad, often the components that cause a dryer to stop working are extra options that are present that a different brand doesn’t have. On most residential washer and dryers they come equipped with what is known as a PCB board. This board is what is behind the buttons that you press to start the dryer. When an option goes that doesn’t prevent the dryer from starting the only way to fix it is to replace the main control board.